Here is a link to a kit similar to the one I used in this video for any ~95-05 GM 3.8/3.4/3.2 motor: http://amzn.to/2ztqakw In this walkthrough I replace the head gaskets, upper intake manifold (UIM) gaskets, and lower intake manifold (LIM) gaskets on a 1997 pontiac bonneville. These steps will be identical for almost any GM 3800 / 3400 / 3100 series II motor. If you have any questions feel free to post them on the video and I'll do my best to try to help! Here is a link to the the text walkthrough I used as a guide for making this video: http:// Also here's a list of torque specs for most of the motor: Camshaft Bolt: 74 ft/lbs + 90 degrees angle torque Camshaft thrust plate: 132 in/lbs (T30 torx) Front cover bolts: 15 ft/lbs + 40 degrees angle torque Oil pan bolts: 125 in/lbs Crank sensor nuts: 18 ft/lbs Camshaft sensor bolts 48 in/lbs Lifter hold-downs: 22 ft/lbs Rocker bolts: 11 ft/lbs(132in/lbs) + 90 degrees angle torque Lower intake bolts: 132 in/lbs Supercharger bolts: 17ft/lbs Crank Bolt: 111 ft/lbs + 76 degrees angle torque up to 10/98 111 ft/lbs +114 degrees angle torque 10/98 and up Cylinder head bolts: 37 ft/lbs + 130 degrees + 30 degrees up to 10/98 37 ft/lbs + 120 degrees Flywheel/flexplate bolts: 132 in/lbs + 50 degrees Exhaust manifolds: stud/nuts 132 in/lbs Nuts 156 in/lbs Oil filter adapter to timing cover: 22 ft/lbs 97 earlier 132 in/lbs + 50 degrees 97 and later Oil pump Cover to timing cover: 98 in/lbs Pick up tube and screen: 132 in/lbs Valve cover bolts: 89 in/lbs Tstat bolts: 21 ft/lbs Water Pump: 132 in/lbs + 80 degrees Water pump pulley: 115 in/lbs Throttle body: 84-89 in/lbs Fuel rail nuts: 75-84 in/lbs
Copyright © 2019 HAFID INTERNATIONAL LIMITED All rights reserved.